What width of units will fit with 120mm rib bed and are there any combined sink\hob units available to fit into worktop and fridges to fit into units.
Side Units With 120mm Rib Bed
- Thread starter D A Williams
- Start date
Yep, my RIB is a 120. Worktop is 39cm deep and has a Dometic hob/sink combo in it. One thing I hadn't really noticed before is that the worktop is shaped slightly to allow for the window cassette, i.e. uniform 39cm but in front of the window where the hob/sink is this sticks into the van more.
Evo's response to my measurements enquiry:
All our kits are the same width for the 3/4 beds at 42cm . If you measure from the C pillar behind the passenger side across the van at 450mm high ( seat level) you have 118cm to the sides of the units. You should able to check if you bed will work.
I've got 7.4 units fitted and the measurement between the furniture and the nearside above the rear wheel arch is 1205mm so a 1200 bed could be a cosy fit
All our kits are the same width for the 3/4 beds at 42cm . If you measure from the C pillar behind the passenger side across the van at 450mm high ( seat level) you have 118cm to the sides of the units. You should able to check if you bed will work.
I've got 7.4 units fitted and the measurement between the furniture and the nearside above the rear wheel arch is 1205mm so a 1200 bed could be a cosy fit
Measuring as above, I have nearly 124cm to cupboard side - there is about 1cm giggle room but, once you start eating into this, operating the handles to flip (located on the passenger side of the seat) would be very difficult. Also, whilst the bed frame and seats are 120cm, the handle adds around another 2cm to the width at the point being measured above, consequently, if you have less than 122cm to play with, measured from the C pillar, it's fair to say a 120cm RIB wont fit.
