Rear Wiper blank

[MarLou3]

Hi all,

I am just starting to insulate and carpet my SWB panel van amongst lots of other things and wondered if anybody is able to provide a link or an STL file for a blanking cover to blank the wiper motor on the tailgate of a T6.1?? Think this would make the rear tailgate look much neater (I dont have a rear wiper just a place for it to go.

Thanks in advance
marLou

 

[JoshB_]

I’ve been looking at this for a while. You can fit a standard VW cover without the motor being there, there’s 2 other clips holding it in underneath.
Unfortunately my lads 3D printer is only a mini so can’t print something big enough to go over the hole… I think I’ll end up just rear doing the rear card in a new piece of ply and recarpeting.

 

[peteaufc]

Is it this kind of thing you're after? Mine is from a T6, but I don't need it because I installed VanShades...

Pardon our interruption...

 

[MarLou3]

Is it this kind of thing you're after? Mine is from a T6, but I don't need it because I installed VanShades...

Pardon our interruption...

I was thinking something a little more flush wit the window surround but that maybe an option