Lashing point / seat bracket locations

[Dobbingtonio]

Hopefully a simple question, but can’t find the answer after lots of googling.

Are the seat bracket and lashing point locations consistent across shuttle/kombi and standard panel vans?

I have a ‘22 shuttle and have been searching for a ply floor. I’d rather avoid templating and cutting out for all the bracket/lashing positions. I’ve found a kombi floor with a 1+1+1 config which I’m hoping would mirror across for this row and lashing points. It would be a much simpler job to cut out the rear row with the middle as a guide.

 

[Jp5037]

Pretty sure the points are the same on all swb vans, my t5.1 was definitely the same as the t6 I just completed this weekend but I only did the 2+1 when opening slider. I’ve still not fitted the mat so will check the dimples in the floor for the other rows and confirm

 

[Jp5037]

This is my SWB layout of seat configurations if it’s any help

 

[Dobbingtonio]

Thanks! That front row is the same as mine with three single seats. Thinking it through more I assume the seat bracket positions must be the same or there would be too many variations in seat options.

So worst case I can buy a kombi floor with 1+1+1 bracket holes in the middle row, then use the shuttle carpet I remove from the van to mark the other cuts.

 

[Jp5037]

No probs yes that would work! I’m looking at mine and a bit confused tbh, not that it makes any difference to me as I only require 2+1. It seems like my middle row could have 1 tripple or 2 larger singles (never seen those) with a gap in the middle, the back row only has 2 dimples so don’t know what that’s about unless they just chop off LWB floor pans

 

[Skyliner33]

It seems like my middle row could have 1 tripple or 2 larger singles (never seen those) with a gap in the middle,

Or a double that could be put on either side?

 

[Jp5037]

Oh yeah now I see it duh