Fresh water bottle solution?
- Thread starter sipep
- Start date
Yes that’s how mine is done.
The hole has to be large enough to fit the siphon through it which leaves a gap around the pipe which I presume is needed to let air in to the container.
I only fill the bottle when I arrive at my destination, so I just remove the lid and leave it off.
I've never used my on board water or the sink in 6 years mainly because the storage area for it was a right PITA to fill it or swap it over but it makes a great bit of storage for towels and telescopic awning poles water container on a table outside works fine for us
I drilled two holes in the lid, one for the hose/pump electrical cable and a much smaller one to let the air in. I then reconnected the pump. I also secured the plastic container with a Velcro strap to the inside of the cabinet. We’ve never had any spills, and it means we don’t have to empty the container before driving to our next location.
Last edited:
Going to do this mate. Thank you
I drilled the vent hole in the top of the handle!
I use a self priming pump now so only a hole for the pipe in the lid and have a spare lid without a hole for carrying to and from the stand pipe.
I use a self priming pump now so only a hole for the pipe in the lid and have a spare lid without a hole for carrying to and from the stand pipe.
We're the same but it's been nearly 4 years for us!
