Search results for query: egr

Hi there, I'm looking for a part no for gasket between cooler and EGR - I plan to recover EGR rather than replace it, but nowhere can find the part no for the below element (see red/yellow indication). thx I assume it should look something similar to this: but how to get part no for it?

Hi - I had a code, P0401 EGR 'A' flow insufficient detected. Low milage (35k) but recently lots of shorter journeys and it's 8 years old so I just replaced with a new Valeo EGR. It is a CAAC engine (no adBlue). Reset codes, bled coolant and it was fine for 200 miles or so. The engine was mapped...

Looking likely that the some part of my EGR system is going to need changing, now the emissions warning light is permanently on. Since is a 2018 204ps CXEB engine, I'm paranoid that throwing away a large fee on the EGR is a waste, if the engine block is going to need changing. Am I causing...

...Seems to be running OK but a bit of rough idling I guess (but nothing major). I rang the code check and got back p0401 - insufficient air flow EGR. So I guess the EGR is blocked or the value is faulty? Hefty quote for the mechanic. Wondering if I need to bother to replace the EGR or I can...

Well, it's EGR time again! I bought the van nearly 5 years ago at ~99000 miles. I'm sure I saw a receipt for a new EGR' in the paperwork but I can't find it now. Either way, the date of manufacture of the old (aftermarket) EGR is 2018 and the van (Euro 5, 140) was registered in January 2016...

...leaks and stains with the trusty brake cleaner to find the sources, I have ran into another issue.... I noticed one of the bolts behind the EGR pipe(?) was soaked in oil. I thought right away that the joint might have split at the flange and it's leaked onto the bottom bolt. I went to take...

Hi all Had my egr blanked and mapped out for the obvious reasons, im away on the first trip and I have noticed that the van is using massive amounts of adblue ie started with 5000 miles range, I have covered 700 miles and it is down to 2000 miles range so at this rate it is going to be using...

Hi, I'm about to do a preventative EGR strip out and clean at 45k miles on my 2019 CXEC bi-turbo. Trying to obtain correct pipes before I start as these will be replaced whilst I'm at it. I understood the rear pipe was upgraded to a cast design with part number 04L131521BH. However the VW bot as...

Brand new set of Tafmet EGR blanking plates and gaskets for the T6 2.0 Tdi engine. One medium and one small blanking plate included. Note these will not fit the Transporter with the slightly longer EGR Pipe (original part 04l131521AK). Cost me nearly £30 due to the international delivery from...

Noticed my van has the EGR disabled with no warning lights. Can I simply plug it back in. I would have thought, it had been closed via software then unplugged to stop a further signal operating it again or am I completely wrong?

Hello all, 40k and it looks like my EGR cooler is blocked up… 5 gear , 102bhp i think I was going to just replace the cooler however a garage informed me that the EGR would not need blanking off if the valve was still working. The cost to delete is not far front he cost of a new cooler as I...

Hello we purchased a T6 EGR cooler delete kit for a 2016 204 bi tdi which consisted of the pipe and the blanks. Darkside kit. we have a video of the issue we're having since we fitted the kit, but I am unable to post here. we're getting a strange blowing sound coming from above the rear EGR...

...are also so many threads on the topic so while I'm trawling them for information I thought I'd post the VCDS log... 2 Faults Found: 15560 - EGR Sensor 1 P046C 00 [01101100] - Implausible Signal Intermittent - Confirmed - Tested Since Memory Clear Freeze Frame: Fault Priority: 2 Fault...

So my van has a Pendle remap. The EGR valve has died. The garage says they could just do a delete but it’d need mapping out but they can’t do it as my van is already remapped. Is there now way round this or do I have to get a new EGR?

Hello, can anyone recommend a garage or mobil to blank and map out the EGR on my 204BiTDI T6, I'm in sunny Stoke-on-Trent, but willing to travel a short distance, many thanks

Hello, Im about to remove the EGR system on my T6 CXFA. But i was wondering instead of just install blocking plates, can't i just remove the whole EGR cooler/Valve and just plug the water hoses? Thanks :)

Afternoon, I've read about the Tafmet EGR simulators on this forum and think this is a good solution to just blanking/mapping/replacing the EGR. It seems that the majority of them are for the BiTDi engines and there is nothing directly listed for the EU5 140 engine. I wrote to Tafmet who said...

Evening all, Does anyone know the part number(s) for the front EGR pipe, gasket and bolts? I've seen a few posts about it all coming as a kit but I can seem to find them anywhere? Failing that, the gasket and bolt part numbers would be really useful as I have the PN for the pipe itself. Many...

Hey guys, Had the tdi400 remapped this week at a local place in Perth. Only reason was to map out the EGR function and stage 1 tune. Not blown away by the tune in the slightest having barely noticed a difference and also when I picked it up on Tuesday and plugged Carista back in the DPF was...

I just replaced the EGR valve and cooler on my CXGB 2016 T6, and it seems to be running well. Do I need to do any calibration / adaptation with VCDS or similar?