Search results for query: Start stop

The only thing I don't seem to have working is Start/Stop... it has an button/switch choice configuration on my T6.1. I need to investigate this...

Yes euro 6 stop start

So it starts. Where it stops nobody knows.

It’s normal for stop button to stay on screen after a function has completed, you have to manually stop it if you want to start it again

My van has that wire connected to the battery treminal - It does stop the Stop/start from working if disconnected. There is another thread on this forum about it.

ok, so you need to correctly wire your dashcam into the correct fuse section that isn't inline with start stop, that's easy to do. in relation to your battery replacement was the vehicle programmed to let it know it had a new battery installed?

Does it need to be anything specific in relation to the start/stop aspect as can see specific batteries for this listed?

get a longer vid clip too, from the engine bay... here is an example of my 2017 CXHA 150 Bus - crank-run-stop. (Hot Start) https://photos.app.goo.gl/rzQLYymF4kAXadcE6 .

As far as I understand the way that these devices work is the if the stop start was OFF when the ignition was turned off them it remembers that. WHen you next start the van, the stop start will come on, the module then recognises this and “pushes the button’ (sends a signal) to turn the stop...

100% needs to be connected for start/stop to work…

I wonder if a previous owner had disconnected it on purpose to disable the stop/start?

Its always present now. Used to be intermittent but now present all the time, along with start stop fault. Even after clearing codes from diagnostic stool

If it's a 2015 T5.1 with stop/start it will need coding in. The second check is to see if it has the sensor on the battery NEG terminal.. Drop us a pic of the battery terminals and we'll have a look. Any 🤞 cal garage should be able to code it.... Or Halfords etc.

...are you getting any errors logged in VCDS for anything not charging/battery related? stop start is one of the first things that gets canned if the whole vehicle electronics isnt in tip top condition with no errors, so if you have any faults, sort them first and you will likely find...

could be a number of reasons, the sensor is out of alignment due to impact for instance. or the vehicle battery is low (does your start stop work?)

The fan runs weather hot or cold stays on goes off briefly but then just kicks in again the start stop just comes up as eating on start up but if i drive with it sometimes goes into limp mode so always have to turn it off no over heating issues lost slight bit of coolant but no sign of leak...

Cheers Lee. 1 thing less to worry about.

New battery installed and coded by the garage. It’s definitely a happier van, the pioneer head unit doesn’t restart with the auto start stop

What model is your van? Depending on the model/age it is possible on older models to disable stop/start via VCDS by changing parameters to make it think that it does not meet the required conditions to work, and I think this can cause messages on the dash. This is typically the stop/start...

Does the van still start/stop ? That's usually a good indication of the battery health.