T6.1 3rd Row seats ??

[GreenTarzan]

Hi all,

After having way too many kids.. We now have to install a 3rd row of seats to our T6.1. Set up currently still standard for van since we bought it. We have 71 plate T6.1, LWB DSG. No mods as of yet but looks like we are about to embark on that journey!

We want to keep driver and passenger seats single so no bench seat in front. Ideally all we need is one seat as the 3rd row but not sure if this is possible, so single or double preferable, if a three row bench (2+1) is all that's achievable it is what it is!

Can anyone help with advice, sourcing of seats, someone decent to help with installation or all of the above! We are situated just outside of Bristol and Bath..

Thanks!

Tom

 

[ChrisBell]

If it was me @GreenTarzan I would look for an outer Tourneo custom rear seat from the middle row. No messing with seatbelt as on seat. No messing with isofox adaptors as already on. Rails can be raised on floor or flush mounted. Again can pick up handy enough! Seats fold and tip up. Yes quite heavy to lift but not impossible. .just need to look at anything that could foul bolts below van. Fuel tank etc? Exhaust? Not sure. And get signed off by right person to make sure install safe.

 

[Pontius]

Can put one single there, two singles or a triple bench - this is what I have in my third row LWB. I sourced two singles and use one to two of them and when needed, swap them for the bench.