Machinist to increase ET on 20” wheels.

huw169

Black 199 Shuttle
VIP Member
T6 Guru
Hi all
Anyone have any recommendations for wheel machinists in Hampshire, ideally Portsmouth, but I’m prepared to travel a bit.
Thanks
 
How about trying an alloy wheel refurb outfit? They machine the diamond cut faces of damaged wheels
 
Need to be careful with how much you want to take off. A lot of wheels are drilled from blanks so the amount of metal between the mounting face of the wheel and the seat for the bolt (the depth of the bolthole) is usually the same no matter what the offset is. It's not like there a whole lot of extra metal there on wheels with low offsets.
 
Need to be careful with how much you want to take off. A lot of wheels are drilled from blanks so the amount of metal between the mounting face of the wheel and the seat for the bolt (the depth of the bolthole) is usually the same no matter what the offset is. It's not like there a whole lot of extra metal there on wheels with low offsets.
I’ll still be within spec. Check with manufacturer.
Thanks
 
Back
Top