Hertz Power 5 and MP 300 D4.3 Pro

[IndyT6]

Looking for a bit of assistance with how to configure my system. I want to drive tweeters/mid range and sub from an ML Power 5 amp. The amp has outputs for 2 pairs of speakers, and sub output.

When used in the configuration the amp will provide: 5 Ch: 70 W x 4 + 380 W x 1 (4Ω)

The sub spec data is saying 600w continuous / 1200w max into 4Ω

If you're reading this I expect you already know what I'm going to ask! Sub spec 600/1200....amp 380w - given that bass is power hungry am I configuring a system where the sub is under driven?

I'm guessing I'm worrying about nothing but wanted to see what the general view is.

(note: mid bass being driven by an ML 400)

 

[IndyT6]

bump bump - anyone any ideas?

 

[Absolut5]

What sub is it, and what type of enclosure , location ?

 

[IndyT6]

What sub is it, and what type of enclosure , location ?

Cheers for reply:

Sub - Hertz MP 300 d4.3
approx. 30 litre ply enclosure (I think Hertz say 27 litre sealed) - 3 ft behind front seats, centre line of vehicle with a firing angle toward head height.
Bolted to 12mm floor.

 

[Absolut5]

That is a dual 4 ohm sub, so will run at 550wrms @ 2Ohm from that amp

 

[IndyT6]

Thanks - I think the "dual 4 ohm" is what I didnt' understand. That really helps - thank you for messaging, especially given I know how busy you guys are.