Factory swivel photo request

PaulR83

2020 T32 199 DSG
VIP Member
T6 Guru
Hi,
I have a request for a picture of the clearance under a factory swivel. I've looked around and cant see any. I've got a leisure battery and rusty lee with risers and its just way too high. I need about 10mm gap under the factory swivel mechanism to the top of the base I think to clear the battery.
looking at buying a factory one, but need to check clearance first. I've priced up all the bits individually, but think it works out cheaper to buy a new seat, swap over the bases, then sell on.
Thanks

20220828_134649.jpg
 
Here is a few with a 190mm high battery

C480681B-13E4-4349-9ED7-7A03928C3B9D.jpeg8B50F34C-50FC-41A6-B9C1-6452A02E93F5.jpegAAFDA610-47B6-447D-A64E-C34BA4325C3E.jpeg
 
Perfect. Thanks. Looks like there is a good cm or two above the base in pic 2. I take it there is plenty of room above it inside. Does anything actually twist or some close to the battery below?
Just about to take the plunge and it's an expensive decision.
I need to rebuild my seat onto the swivel one too. Fun and games.
Thanks again

20220828_135240.jpg
 
I’m out at the mo. When I get back I’ll take a measurement for you.
 
Thanks again. Would be really appreciated
The current swivel has bolts that drop down and foul it so have the RIB risers added. So not happy with the height or wobble

20220829_154520.jpg
 
Back
Top