DPF reset

[DJH]

I’ve had the flashing coil and engine light come on on my euro 6 2016 shuttle (cxbg engine) and when I read the codes it said the DPF was at 59.9g of soot. I’ve had it washed out, and the garage said to reset it and tell it that a new one has been fitted.
Where in VCDS can I find the option to do this?

 

[Robert]

I dont know your full story but in principle you should do the following.
Go to Engine Control Unit(address 01), select ADAPTATION, choose "ash reset" and set it to 0.
If your DPF has been in deed cleaned successfully you should also perform "dpf forced regeneration while driving" this one is located in the ECU under BASIC SETTINGS.
And hopefully that's it.

 

[DJH]

Thanks for that, I’ll have a look when I get home later.
The pressure in it is a lot lower after it’s been cleaned through. I was looking for the reset in the same menu as the regen.
The garage did say to regen it, then to change the oil too.