Just had a 'the conversion' done by stitches and steel. Very happy with it and getting some good multi use already.
The bed sits up against the roof when not in use. I'd like to put some lighting in the back and now have these lovely panels with lots of holes in them, as you'll see in the photos.
I thought it would be nice to stick some lighting behind the rear quarter upper panels and sliding doors. I'm talking more ambient than anything. The main lights will stay in the headlining panel for when the bed is down.
So I'm asking for any info advice or ideas of how to achieve this. Regarding what to use. Where if possible to tap into the loom or what other ideas might be out there.
Ta
The bed sits up against the roof when not in use. I'd like to put some lighting in the back and now have these lovely panels with lots of holes in them, as you'll see in the photos.
I thought it would be nice to stick some lighting behind the rear quarter upper panels and sliding doors. I'm talking more ambient than anything. The main lights will stay in the headlining panel for when the bed is down.
So I'm asking for any info advice or ideas of how to achieve this. Regarding what to use. Where if possible to tap into the loom or what other ideas might be out there.
Ta
