If you leave it idling too long during a regen itll abort the process (unless its very close to the end) and will have another try next time the correct operating conditions are met.
...keep a close eye on my levels so I'm happy enough to ignore it.
Nevertheless, it makes me wonder how many folk have suffered this fault and just happened to have a high oil level due to slipshod servicing and then went on to add two and two together and come up with "oil dilution" when it...
It’s fine to switch off once the revs drop to normal. This negates the risk of oildilution due to fuel from the regen.
Next time you drive the van it will carry on with the regen. I have checked this many times since the tech told me using vcds and mostly VAG DPF.
Edit: Idling does not...
I bought new 71 cali came with reduce engine oil light on apparently software issue open bonnet close it was told this just resets it i believe this van has only covered 11700 miles so I have took to vw 4/5 times for this problem they have taken oil out of this van twice while under warranty...
Just because the warning light doesn’t illuminate doesn’t make everything OK. If the oil is black / brown (no water emulsification) and the oil level is rising without anybody adding oil it is due to fuel dilution.
Fuel dilution at just 2% will damage an engine / turbochargers.
Have a search...
...I've stopped, it interrupts the regen and the revs drop from the regen 1000rpm to the normal 800rpm then wait another 30 secs or so. This means what I turn off the van isnt injecting diesel so reduces the risk of oildilution. The van completes the regen as soon as I set off on the next journey.
Some how get the EGR disabled.
Oil service at no more than 8000 miles, even with the EGR disabled the soot level will be close to the Caution threshold by this point. (Based on my 180 ps analysis).
Oil analysis every 4th oil service.
Don’t use for short journeys.
Monitor the DPF status with...
...change, truth is I never checked it after the service or up until now. So it might of been overfilled since then. Or it's the dreaded oildilution from regens.
I've booked it in immediately for an oil change and new filter, and it won't be driven until then.
My question is, should I sent...
...a service I remove between 400 and 500 ml of oil through the dipstick tube to reduce it down to halfway. Initially I was worried about oildilution so I sent a sample to Miller's for oil analysis, no worries from the results.
I'm lucky my van doesn't use oil, I'm sure it's just oil...
It doesn't occur. Excessive dilution is all but unheard of on these.
The warning messages are simply a case of garages brimming the oil to the top mark on the dipstick or even beyond. Sooner or later this upsets the sensor.
Once the oil level is reduced to around the halfway mark the warning...
For that price you need to ask what you are getting, injectors, pumps and valves should be overhauled in a clean room as the operating clearances are mere microns, they then need to pass a stringent test procedure.
For £144 inc VAT I suspect the outcome won’t be good.
A failed injector can bore...
From reading this, I would certainly want to change the oil if it has been diluted by fuel. To not do so risks excessive engine wear by the sounds of it. So why are dealers just siphoning off the excess?
@Ian Watt, what did VW assist say?
Kind of what I’m doing currently to be honest. Pre-empting at the moment as my regen frequency is the biggest red flag indicating it’s getting blocked.
But such frequent regens also bring their own problems right? Like a rather unreasonable MPG and oildilution?
Where did you got a brand new engine and how much did it cost?
Also did the new engine come with any upgraded parts? How can we know that if we invest in a new engine or a rebuild this issue won't happen again in 50 k km ?
Have a Search with ‘dilution’. Plenty of content on the Forum.
If your oil level is rising without anybody adding oil there are two possibilities:
1. Coolant contamination - emulsified oil, obvious.
2. Fuel dilution - not obvious at all and with a 2% diesel contamination limit before accelerated...
Bit more from Gemini AI premium
The conflict between "official technical specifications" and "real-world dipstick readings" for the T6.1.
For your specific CXHA engine with the 4BH code, the technical data is clear, but the implementation is where it gets tricky.
Why the Two Figures Conflict...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.