Search results for query: cable under passenger seat

I have had an Alternator Charger and Delta 2 installed in my T6.1 California since September, and it's truly been an awesome experience. I hooked it up to the factory leisure battery under the passenger seat, and occasionally do reverse charging, and everything works wonderfully. However, I've...

Same as me. I used as much of the original installation under the passenger seat as I could. I replaced the VW split charge relay with a fabricated box that fitted into the space left and that clipped in using the same attachment method. Inside this box is a midi fuse holder with a 60A fuse that...

My 2022 T6.1 is the same as that under the passenger double seat.

How did you get on with moving the factory electrics from under passenger seat, where did you reposition them to? I’m also trying to work out if I can move all my cables etc over to the drivers seat, as the cables seem to come from the direction of the centre of the cab area. But not taken seats...

Nice set up here putting it under the seats. Good to take full advantage of space under passenger bench seat as well. I reckon I'll be going for the same sort of set up in my T6. I just have a few questions: 1/ Fuse box for circuits from leisure battery Are you putting all fuses under the...

The control module would normally interrupt the door signal so you would cut the wire under the passenger seat and join the spare cable to the dash side of the cut

The 18a DC-DC is a little smaller and runs cooler so may fit under the drivers seat. The only way to tell is to remove the seat and lay it all out to see if they will fit. The same with the passenger seat if you need to use under there. The swivel won’t stop you but may limit the height...

In an ideal world I’d put the DC-DC under the passenger seat to minimise the length of the cable runs but ultimately it will be whatever fits where, especially if you are wanting to use existing cables. I can’t remember the detail of your existing cables but swapping out for an 18a DC-DC may...

Wayne I have installed this and it’s really straight forward. It’s a great bit of kit. As far as I’m aware your heated seats might have to be sacrificed due to the mechanics of the swivel but the wires hide under your floor mat easily. DM if you have any questions mate. It’s a great bit of...

2014 (63 Reg) Transporter 2.0 (1968cc) T28 140 TDI SWB - 136K miles, FSH. Indium Grey. 9 months MOT. Usual Highline spec', 6 speed manual, Pioneer ApplePlay HU with Rainbow speaker upgrade, Reversing sensors, MFSW. UK Pop Tops roof, RIB 112 seat/bed, VW multirail and rubber on NS for awnings...

Routed from inside the van via the top of the passenger wheel arch breach in the fire wall. It comes out to the rear of the battery compartment. Red to battery, black to the head light bracket with a little scraping to ensure a good earth. Inside I routed the cable under the dash behind the...

Both are pretty much used, the factory fit option goes under the passenger seat. There tends to be more factory electrics under the passenger seat so if the drivers seat is free that can be easier to retro fit, especially if choosing a larger battery. There are cable routes to both seats from...

Dead easy. I lift the carpet slightly (with the passenger seat base out) and there's loads of room to get my arm pretty much elbow deep - I can then push the cable through from the (still fitted) drivers seat base and grab it with my hand. The carpet in the Caravelle is split just behind the...

I left mine on default out of the box setting 4, no hassle.

Fitted the Cerbo GX today! Only plumbed in the MPPT 100/20 so far, it works! VRM portal sorted too! Van wifi (thanks be to @TallPaul_S ) Tomorrow the S4 Roamer 230 (upright not seatbase) turns up, that's going under the wardrobe where my existing gen 1 Roamer lurks now. The rest of today will...

Yeh I’m pretty sure you can access from underneath as you can see part of its cabling through the sump guard. I think someone got their head in for a nibble - arse!

Like a lamb to the slaughter , hopefully to obtain some good advice from the Electrically minded on here . I have been pondering the layout & leisure setup in my new van for a while. I did go down the Roamer design route but it was all bells & whistles and would of been unnecessary for my needs...

All makes sense. Without the induction hob a 105ah would do you fine by the sound of it (same use as me). That would fit under your seat and keep the wiring, fusing and charging requirements lower and more likely compatible with what you have. Using a power pack for a portable induction hob...

I just got my order in for one. The question now is where to fit it. My camper was supplied with the factory-fitted auxiliary battery under the passenger seat and it seems a bit cramped under there so I’m wondering whether it be better to put it under the driver’s seat where there’s much more...

I learnt a lot from this thread so wanted to share my Xmas progress for others to get ideas on their journey. So I decided on to do my own electrics, and needed to get the basics in before our roof comes off in January. We elected to have a seat base battery under the passenger seat and route...