Search results for query: grommet

...holes through both skins, open up the one inside so the 10mm nut can pass through and using the supplied hardware to bolt it on and shove a grommet in the hole. Nope. The tailgate is triple skinned in that area which means the studs are not long enough and even if they were the middle skin...

I've got the same job planned for tomorrow, feeding a couple of 12v LED light strings power wires through that barn door grommet into somewhere near the base of the wardrobe to get power from the Cerbo relays, while I'm in the wardrobe I'll be getting the solar cables ready for my new Renogy 220...

Excellent news, glad you got sorted.

...patient particularly with getting head unit in. Cables went though dash, up pillar across in headliner and then behind cupboards through a grommet above right hand barn door to get outside.... I was talking to.an engineering firm to make me a threaded extension to increase stub length to...

Well @PhillH and everyone with the OMTEC VW Roof racks, with missing or worn out bolt covers......what you need are circular rubber grommets, with an interior width of 19.05mm. I bought a selection box from Amazon and the 19.05mm fit like a glove. This was the selection box I bought...

...Or the cables can be run down the side of the tailgate and an entry gland installed by the rear light. If you have barn doors the blanking grommets for a tailgate are ideal. If I was to do it again I’d go inside the canvas to simplify routing and cable handling as the pop top is raised/lowered.

Thanks , there is indeed Wonder how to get the 16mm x 2 cable over to drivers side and then over the door

There's a grommet through the firewall behind the battery ...

Hi Matt, I ordered a selection box of grommets from eBay and found the best fit. They are round but do fit.

...fuse box. I went down the a pillar and then poked the wires through the hole behind the panel of previously removed. Yes. Pull that trim off by your yellow cross and you get to the end of the rubber bellow grommet thing. https://www.t6forum.com/threads/t6-1-interior-mirror-replacement.53874/

Massively useful info, thanks.

...either following the factory wiring (which I think is generally up the B pillar form the underseat area and along the roof) or there is a grommet under the seat to take wiring outside the body and along to the back (suitable protection needed) If the intent is to run a fridge I'd not use the...

I looked into this route and pretty sure it comes out of the grommet in the bottom left of this photo.

I think that is a very elegant fitting! does it have an air gap between roof and panel? As is on the image can you fit under barriers? :)

Yeah I might do something like that. Thanks.

If the holes wee hidden from view you can pop some blanking grommets in there.

The instructions are printing in black and white and they contradict themselves, pretty poor instructions to be fair. I dont mind cutting out under tray. At the front of your van on drivers side did you have two holes? One either side of the thin piece of steel that runs down front to back? I...

There the same brackets i fitted to mine. They line up with the rubber grommets as per the instructions( if you have them) The undertray needs to be cut out to mount them.properly. Haven't got any pics of fitting them unfortunately.

What’s stopping my cables from going from the tailgate grommet to the hinge grommet on the RHS? I’m trying to ad solar cable and wanted to run it across from one side to the other inside body work but it stops half way. I have Barn Doors

Thanks. Lots to decide between.