Search results for query: grommet

Thanks , there is indeed Wonder how to get the 16mm x 2 cable over to drivers side and then over the door

There's a grommet through the firewall behind the battery ...

Hi Matt, I ordered a selection box of grommets from eBay and found the best fit. They are round but do fit.

...fuse box. I went down the a pillar and then poked the wires through the hole behind the panel of previously removed. Yes. Pull that trim off by your yellow cross and you get to the end of the rubber bellow grommet thing. https://www.t6forum.com/threads/t6-1-interior-mirror-replacement.53874/

Massively useful info, thanks.

...either following the factory wiring (which I think is generally up the B pillar form the underseat area and along the roof) or there is a grommet under the seat to take wiring outside the body and along to the back (suitable protection needed) If the intent is to run a fridge I'd not use the...

I looked into this route and pretty sure it comes out of the grommet in the bottom left of this photo.

I think that is a very elegant fitting! does it have an air gap between roof and panel? As is on the image can you fit under barriers? :)

Yeah I might do something like that. Thanks.

If the holes wee hidden from view you can pop some blanking grommets in there.

The instructions are printing in black and white and they contradict themselves, pretty poor instructions to be fair. I dont mind cutting out under tray. At the front of your van on drivers side did you have two holes? One either side of the thin piece of steel that runs down front to back? I...

There the same brackets i fitted to mine. They line up with the rubber grommets as per the instructions( if you have them) The undertray needs to be cut out to mount them.properly. Haven't got any pics of fitting them unfortunately.

What’s stopping my cables from going from the tailgate grommet to the hinge grommet on the RHS? I’m trying to ad solar cable and wanted to run it across from one side to the other inside body work but it stops half way. I have Barn Doors

Thanks. Lots to decide between.

...off. Or you can drill and nut and bolt to the seat base. Or you can drill and rivnut to the B pillar. Or you can drop through the floor grommet and drill and bolt into the lower chassis rail. Or you can go a bit further back and drill and bolt, in the framework behind the first panel in...

Thanks, that put’s my mind at rest! Could not find the elusive firewall grommet on the drivers side and don’t fancy removing the dash trim..

There is a hole in that location, so any roof bolt leaks or leaky grommets might come out there. You can see the holes here: https://www.t6forum.com/threads/candyvan-conversion-journey.37860/post-515944

I’ve managed to thread a waste pipe up through the grommets and fitted a drop vent Great info on here as usual

...worked great. New hole in metal roof. I’ve moved it onto a raised channel so there’s less chance of water sitting there. Plastic grommet fitted. I will seal it before final fitment. MPPT and isolation switches fitted to rear cupboard panel. The Sargent goes below it. Cerbo screen...

...and will be able to screw my panel to that. I’m still waiting on the VE cables for the Cerbo and the Roamer/Cerbo cable. I’m about to disable the existing solar panel and controller and fit the MPPT. I will pick up more rubber grommets and finish the power wire under the bonnet today also.